WO, Solex, YS Carburetor Heat Shield, Stainless, 1941-1953, MB, GPW, CJ-2A, CJ-3A, M38 CJ3B Stencils

WO, Solex, YS Carburetor Heat Shield, Stainless, 1941-1953, MB, GPW, CJ-2A, CJ-3A, M38 CJ3B StencilsAnother hard to find original Willys partthe carburetor heat shield! These are made by Vintage Jeeper. If youve ever battled carburetor heat soak, you know how frustrating it can be. On vintage Jeeps, the carburetor sits directly above the exhaust manifold, which transfers a tremendous amount of heat upward. Flat style shields dont solve the problemthey trap heat under the carburetor and turn into a hot plate. The original Willys design used angled

Jeepster Commando (1967-1971) w/ Dana 27 Front Axle

Replacement distributor stator

Fog lights 5" w/hardware & bracket

Red reflector used above rear tail lights and as a side marker on 1969-1970 models before marker indents were molded into the body

CJ-3A (1948-1953) w/crossover conversion

Jeep Pickup (1947-1950) w/ 4-134 L-Head engine

Welding is required

and early CJ-5 models often suffers from excessive play

Verify mounting configuration before installation

See attached instructions

Comes with every gasket you need to entirely overhaul and reseal your 226 engine

remove before installationInstall with groove facing outward from transmissionMust be fully pressed onto main shaft or transfer case will not seat properlyVerify transmission type before ordering